Round up or down?

Round up or down?

Postby chelseachao » Mon Jun 11, 2018 8:38 pm

Hi,

I have a question regarding the plumbing fixture calculation. Let's say you have a total occupant load of 300, and Plumbing Code requires 1 water closet per 100 for both men and women. Assume the men and women are evenly divided. So number of WC required for men or women is (300/2)/100 = 150/100 = 1.5. Now, should we round this number up or down? I think it should be round down because it says "1 per 100". But some people think it should round up if the digit in the tenth place is >=5, and round down if it's <=4. What do you think? I've seen similar questions in the exam and want to make sure which way is correct. Thanks!
chelseachao
 
Posts: 1
Joined: Mon Jun 15, 2015 7:10 am

Re: Round up or down?

Postby Coach » Mon Jun 11, 2018 11:26 pm

Read the footnotes.
User avatar
Coach
Site Admin
 
Posts: 13192
Joined: Wed May 23, 2012 2:08 am

Re: Round up or down?

Postby thd7t » Tue Jun 12, 2018 6:07 am

chelseachao wrote:Hi,

I have a question regarding the plumbing fixture calculation. Let's say you have a total occupant load of 300, and Plumbing Code requires 1 water closet per 100 for both men and women. Assume the men and women are evenly divided. So number of WC required for men or women is (300/2)/100 = 150/100 = 1.5. Now, should we round this number up or down? I think it should be round down because it says "1 per 100". But some people think it should round up if the digit in the tenth place is >=5, and round down if it's <=4. What do you think? I've seen similar questions in the exam and want to make sure which way is correct. Thanks!

Always round up. Even if it requires 1.1 fixtures, round up. It's the same as sizing egress, complying with parking requirements for zoning ordinances, or any other code or permitting issue. You need to have enough fixtures for your users. If you round down, you don't have enough, so your design is not adequate.
thd7t
 
Posts: 356
Joined: Mon Aug 22, 2016 1:23 pm


Return to PPD - Project Planning & Design

Who is online

Users browsing this forum: No registered users and 2 guests