First attempt at the ncarb's online vignette. I test in less than a week. For my screenshots, I tried to zoom in to show more detail (the other two images). Please provide any feedback possible - many thanks. Here are a few assumptions I wanted to double check and other questions I had while drafting:
1. I drew footing+foundation at 6'-0" assuming a 12" footing depth so the top of footing was at the 5'-0" frost line.
2. To find correct duct height, should I find the deepest duct it would relate to and then center the cut duct on the biggest? Then the light fixture and structural spacing are off the largest duct?
3. Similar to previous question but about structural - should we find the deepest structural member to offset from that? Didn't see a change in depth within a floor on this one, but there were beams noted so wasn't sure if that would affect my ceiling height.
4. Should I add a buffer of an inch or two to any of these spacings? I made it as exact as I could, but you know this software... would hate for it to be a bust.
5. Should I have drawn my grade line on the section cut?
6. Should the grade line be one continuous line across the whole drawing?
THANK YOU!