BS Vignette attempt, please comment!

Mechanical & Electrical Plan Vignette and Multiple Choice

BS Vignette attempt, please comment!

Postby Heartwood » Fri Mar 09, 2018 4:49 pm

For this attempt, I changed up the rigid duct runs a little. Max flex duct length is 8'-8" sketch circles for accent lights are 2'-4"

Can you run a flex duct over a light fixture?
Should you run the rigid duct to the center of the supply/return risers as shown?
Can the accent lights be located that close to the fluorescent fixtures, grid, & rigid duct?
Can return grills be located <1' from walls?

Thanks for everyone's feedback! It really helps so much!
You do not have the required permissions to view the files attached to this post.
Heartwood
 
Posts: 19
Joined: Tue Oct 25, 2016 11:25 am

Re: BS Vignette attempt, please comment!

Postby Sparky83 » Fri Mar 09, 2018 5:29 pm

Heartwood wrote:For this attempt, I changed up the rigid duct runs a little. Max flex duct length is 8'-8" sketch circles for accent lights are 2'-4"

Can you run a flex duct over a light fixture? Yes.
Should you run the rigid duct to the center of the supply/return risers as shown? Doesn't matter.
Can the accent lights be located that close to the fluorescent fixtures, grid, & rigid duct? Why would that matter?
Can return grills be located <1' from walls? Yes.

Thanks for everyone's feedback! It really helps so much!

Sketch circles for accent lights appear to be too large.
Sparky83
 
Posts: 7649
Joined: Tue Dec 02, 2014 1:36 pm

Re: BS Vignette attempt, please comment!

Postby Heartwood » Sat Mar 10, 2018 8:42 am

Sketch circles for accent lights appear to be too large.[/quote]

What size should the sketch circles for the accent lights be? I seem to always have a little space in the wall corners that is not covered.
Heartwood
 
Posts: 19
Joined: Tue Oct 25, 2016 11:25 am


Return to BS - BUILDING SYSTEMS

Who is online

Users browsing this forum: No registered users and 1 guest