This alt sucked a lot. Took much too long to get a scheme that works. Let me know what you think. Not sure if I used the posture chairs right. Are they supposed to go in front of the work tables? Can they even do that?
Thanks for help!
sbyrktct wrote:- you can't get around the conf table... best not to rotate anything in increments less than 90 degrees
You used the posture chairs correctly... they and the worktables (drafting tables) are inserted separately and will require separate clearances.
sshust15 wrote:Thanks for the reply! Pertaining to the conference table, I believe my mistake is that the 36" clearance needs to be from the chair. This is because of the angle of the table and the fact that the chair sticks out farther than the corner of the table. Is that correct?
Return to SD - SCHEMATIC DESIGN
Users browsing this forum: No registered users and 26 guests