IL Vignette Review (please)

Interior Layout & Building Layout Vignettes

IL Vignette Review (please)

Postby everduin83 » Tue Sep 24, 2013 9:40 am

Her you are folks, if anyone has the time to review. First timer, first attempt, done in about 50 min... then caught some things and sorta stumbled across the finish line. I think I got it but be gentle, ;-). Work table is funny but I think it would still work.
You do not have the required permissions to view the files attached to this post.
Last edited by Coach on Sat Sep 28, 2013 2:40 pm, edited 1 time in total.
Reason: Don't post programs.
everduin83
 
Posts: 15
Joined: Thu Sep 19, 2013 9:14 am

Re: IL Vignette Review (please)

Postby zordon » Tue Sep 24, 2013 6:47 pm

It looks like the pull-side door clearance in JO might be overlapping the TFF, but it's hard to tell without the sketch lines in there. Also, maybe someone can weigh in on whether or not there should be a clearance between the front of the desk and the round coffee table in SO?

Other than that, looks good.
zordon
 
Posts: 153
Joined: Sat Sep 21, 2013 5:46 am

Re: IL Vignette Review (please)

Postby everduin83 » Tue Sep 24, 2013 8:00 pm

The TFF I was thinking was going to be an issue in hindsight, I think I probably could have gotten all the clearances if I had rotated it 45degrees.
everduin83
 
Posts: 15
Joined: Thu Sep 19, 2013 9:14 am


Return to SD - SCHEMATIC DESIGN

Who is online

Users browsing this forum: No registered users and 57 guests

cron