This is a second attempt at the 3.1 Ramp. I tried to make sure I would have a 60" turning radius on the double landings since I have a handrail separating the landing from the ground floor level below.
I was a bit confused about the width of the stair. If my 24" landing is 5'0" wide, do my stairs also have to be 5'0" in order not to reduce the width in the direction of egress travel? Since the landing only needs to be 44" (except where it changes direction) can I also make the stairs 44". It's only that once I make my ramp 5'0" (or stairs 5'0") everything after that has to stay at that same width of 5'0". Correct?
Thank you!