Hey Guys! Last first attempt post from me. This time for the stairs!
Couple questions as this one was a bit tougher for me than the rest:
1. With the cut stair tool, I need to enter in the same base and top height 2 times for both the upper and lower sections. These elevations should both be the same correct?
2. How many clicks off the stair/wall should I make the railing? I know we need to maintain at least 1 1/2" on the wall side for clearance requirements. Is 3 clicks the right amount? Would this be the same for the ramp vignette as well? The reason I am asking is to save time drawing sketch lines.
3. Hypothetically, if we need an area of refuge for a mid floor landing, would the second floor stair need to be the 56" wide (including rails) or could it be 44" (or whatever the occupant requires great than 44") from 2nd floor to middle and then middle would be 56" to first floor?
4. Does the landing between mid floor and second floor need to clear the 80" height requirements? I have it at 7'-0" on my attempt which means I only have 6'-0" of clearance below which is not enough. Is that ok?
5. Should I set that same landing before making the stairs in order to figure out how many risers I may need to connect both levels?
Thanks guys!