Please Help! NCARB Program Question Stall & Drive Alignment

Site Grading & Site Design Vignettes and Multiple Choice

Please Help! NCARB Program Question Stall & Drive Alignment

Postby Ashenrider » Tue Apr 17, 2018 6:06 pm

I apologize if this question is asked often, I can not find advice on it and am testing in the morning. When aligning the parking stalls and drive aisles, often the parking stalls will be to one side or the other of the drive aisle line due to snaps built in the program. I have only got it dead on a few times and its very fickle.

In the exam or vignette is this an issue or a factor of the program error allowance? More so will I fail if the parking is a touch over the drive aisle and moving it with snaps in place does not help align perfectly?

Please help!! Thank you
Ashenrider
 
Posts: 13
Joined: Sat Feb 15, 2014 3:01 pm

Re: Please Help! NCARB Program Question Stall & Drive Alignm

Postby Coach » Tue Apr 17, 2018 6:38 pm

All drawing elements should honor the same snap. Zoom in.
If you can't align properly, always make sure minimum stall sizes are used.
User avatar
Coach
Site Admin
 
Posts: 13249
Joined: Wed May 23, 2012 2:08 am

Re: Please Help! NCARB Program Question Stall & Drive Alignm

Postby Ashenrider » Tue Apr 17, 2018 6:41 pm

Coach wrote:All drawing elements should honor the same snap. Zoom in.
If you can't align properly, always make sure minimum stall sizes are used.


Thank you!
Ashenrider
 
Posts: 13
Joined: Sat Feb 15, 2014 3:01 pm


Return to SPD - SITE PLANNING & DESIGN

Who is online

Users browsing this forum: No registered users and 45 guests

cron