vignette- appreciate feedback

Building Section Vignette and Multiple Choice

vignette- appreciate feedback

Postby xanderb » Sun Jun 10, 2018 5:08 pm

Necessary to have ducts tight to underside of joists? I've shown airspace between duct/joist

joist- stop at bearing wall, or show overlapping bearing wall a little bit?

Plenum depth: 32x24 duct max size at floor/clg first floor, I've shown 32" total depth for plenum (24" plus 8") below joist- beneficial to add inch or two in depth for 'wiggle' room or is minimum clearance fine?

Thanks in advance
You do not have the required permissions to view the files attached to this post.
xanderb
 
Posts: 3
Joined: Fri Jun 01, 2018 3:38 pm

Re: vignette- appreciate feedback

Postby Coach » Sun Jun 10, 2018 5:49 pm

xanderb wrote:Necessary to have ducts tight to underside of joists? I've shown airspace between duct/joist

Only necessary if you are drawing the joist and duct that are the max combination.

joist- stop at bearing wall, or show overlapping bearing wall a little bit?

Take a snap or two into wall.

Plenum depth: 32x24 duct max size at floor/clg first floor, I've shown 32" total depth for plenum (24" plus 8") below joist- beneficial to add inch or two in depth for 'wiggle'

No.
User avatar
Coach
Site Admin
 
Posts: 13249
Joined: Wed May 23, 2012 2:08 am


Return to CDS - CONSTRUCTION DOCUMENTS & SERVICES

Who is online

Users browsing this forum: No registered users and 59 guests

cron