Page 1 of 1

Standard Order of Drawings and Consultant Drawings

PostPosted: Fri Feb 16, 2018 2:19 pm
by greenHandle23
The Kaplan study material says that the consultants drawings (the way that they are organized in a set) = P, M, E. Plumbing, Mech, and Elec.
The "Caroline Notes" states this another way on Page 11 of 60 = M, P, E.

So, does anyone have an idea of what the CDS test will look for on the correct answer to this question for standard order of drawings and consultant drawings within a set?

Re: Standard Order of Drawings and Consultant Drawings

PostPosted: Fri Feb 16, 2018 2:36 pm
by Coach
PME is correct as far as I'm concerned, but see if AHPP has anything to say about it.

Re: Standard Order of Drawings and Consultant Drawings

PostPosted: Wed Feb 21, 2018 2:53 am
by fare75
Coach wrote:PME is correct as far as I'm concerned, but see if AHPP has anything to say about it.

I can confirm this from this diagram from Architectural Graphics Standards
(Lowest is on top...poor graphic presentation :roll: )

Drawing_Order.JPG

Re: Standard Order of Drawings and Consultant Drawings

PostPosted: Wed Feb 21, 2018 12:06 pm
by Coach
fare75 wrote:I can confirm this from this diagram from Architectural Graphics Standards

That also shows S before A, which is ridiculous.