Ncarb 3.1 (cut through the elevator)

by **chihirokawaii** » Thu Aug 21, 2014 10:31 am

I notice there are many ncarb 3.1 alts laying around so i'd assume the location of the cut line is different on each practice vignette. Please review my solution. Thanks

by **mkp** » Fri Aug 22, 2014 9:36 am

I have not seen this one personally, but with the cut line going through the elevator shaft, I would think that there would be no floor in the shaft at the start of the second level. The shaft would have bearing walls and would look like the open meeting space theoretically. You all, please correct me if I am wrong.

by **chihirokawaii** » Fri Aug 22, 2014 9:58 am

You are RIGHT! Can't believe I missed that one. Thanks!

-Chi

by **mkp** » Sat Aug 23, 2014 6:14 am

chihirokawaii wrote:You are RIGHT! Can't believe I missed that one. Thanks!

-Chi

That's why we practice, right?? We can get it all out of the way now and not during the test

by **yellowfin** » Sun Aug 24, 2014 10:17 am

I am pretty sure you have not properly calculated the correct joist/duct heights.

by **yellowfin** » Sun Aug 24, 2014 10:18 am

On the second floor there is a larger joist just south of the section cut line that would make the duct/joist area larger than you have drawn.

Ncarb 3.1 (cut through the elevator)

Ncarb 3.1 (cut through the elevator)

Re: Ncarb 3.1 (cut through the elevator)

Re: Ncarb 3.1 (cut through the elevator)

Re: Ncarb 3.1 (cut through the elevator)

Re: Ncarb 3.1 (cut through the elevator)

Re: Ncarb 3.1 (cut through the elevator)

Who is online